Correct installation of wire rope clips

Duplex Wire Rope Clip. Wire rope clips are available in a variety of materials and finishes but basically three types of materials, carbon steel, cast, malleable iron, and stainless steel. Carbon steel wire rope cable clamps are galvanized, or hot dipped galvanized, the galvanised metal wire clamp has an added zinc layer to prevent rusting and protect against scratching and the addition of carbon corresponds with an increase in the hardness and strength of wire rope cable clamps.

G, but stainless steel wire rope clamps are the best choice for corrosion-resistant applications that can be used for saltwater environments.

Stainless Steel Wire Rope Clips. If you have any wire rope clips questions, you can contact us by email at info hilifting. We will be glad to share with you more useful information. Figure 4. If a pulley Sheave is used, in place of a thimble add one additional clip. Clip spacing should be as shown. Figure 5. The preferred method of splicing two wire ropes together is to use interlocking turnback eyes with himbles, using the recommended number of clips on each eye See Figure 1.

Figure 6. An alternate method is to use twice the number of clips as used for a turnback termination. The rope ends are placed parallel to each other, overlapping by twice the turnback amount shown in the application instructions. The minimum number of clips should be installed on each dead end See Figure 2. Spacing, installation torque, and other instructions still apply. This load should be of equal or greater weight than loads expected in use.

Next, check and retighten nuts to recommended torque. In accordance with good rigging and maintenance practices, the wire rope end termination should be inspected periodically for wear, abuse, and general adequacy. Failure to read, understand, and follow these instructions may cause death or serious injury. Read and understand these instructions before using clips. Match the same size clip to the same size wire rope. Prepare wire rope end termination only as instructed.

Do not use with plastic coated wire rope. Apply first load to test the assembly. Next, check and retighten nuts to recommended torque See Table 1, this page. Efficiency ratings for wire rope end terminations are based upon the catalog breaking strength of wire rope. They should be tightened before the rope is placed under tension. After the load is placed on the rope, tighten the clips again to take care of any lessening in rope diameter caused by tension of the load.

A wire rope thimble should be used in the eye of the loop to prevent kinking. The correct number of clips for safe operation and the spacing distances are shown in the table below. U-bolt Clips.